|
Hylafax Mailing List Archives
|
[Date Prev][Date Next][Thread Prev][Thread Next]
[Date Index]
[Thread Index]
Re: Sending faxes
It should work without it. The error message you state below: is that
literally what you get? If so then there is something wrong with your
config. You have configured the modem to be on "device", rather than say
"ttyS1". When you ran faxaddmodem what did you answer to the first
question: "Serial port that modem is connected to []?". You should have
put in the device name.
It is a good idea to run faxgetty as well for a send-only modem, since
it performs various resets that are not done otherwise. If so make sure
you set RingsBeforeAnswer to 0 in the modem config file (that will stop
it actually answering an incoming call).
Damian
>
> Do I need to run faxgetty for send-only modems. I have not done it, I have only
> run faxmodem device. When I run faxstate -s ready device and I get:
>
> FIFO.device: open: No such device or address.
>
> Faxmodem reports no error, but sending is not done on modems that do not have
> faxgetty entries.
>
> Thanks in advance.
>
> --
>
> Sinisa
>
> _/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
> _/ --- ___ \/ - Sinisa Milivojevic, Consultant _/
> _/ -- / o __ o __ ___ - CORES , 11000 Beograd 8-) _/
> _/ - --- / / / / /_ /__/ -- Marsala Tolbuhina 31, SERBIA _/
> _/ ___/ / / / / __/ / / ---- tel:+381 11 4443331,fax: 433001 _/
> _/ ----- http://www.coresinc.com/~sinisa _/
> _/ To defy, to conquer. For us! -- mailto:sinisa@coresinc.com ;o) _/
> _/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
--
______________________________________________________________________
* Damian Ivereigh * || || * Cisco Systems, Inc. *
* MIS Printer Admin * .||||. .||||. * 408-526-4413 *
* Linux Bigot * ..:||||||:..:||||||:.. * 800-800-1180 x64413 *
* damian@cisco.com * cisco Systems, Inc. * Fax: 408-527-2563 *
*______________________________________________________________________*
