Hylafax Mailing List Archives

[Date Prev][Date Next][Thread Prev][Thread Next] [Date Index] [Thread Index]

How to incorporate modem-specific config file?




Hello!

I recently installed HylaFAX 4.0 from scratch (using the RPM) on a
brand-new Red Hat 5.0 system.

I have a Practical Peripherals PM14400FXMT modem.  Lucky me; HylaFAX 
comes with a configuration file for that particular unit.  I am
unclear how to incorporate the supplied ppi-pm14400fxmt file into
my config.cua4 file that was automagically built during the installation.
There seems to be a healthy amount of overlap between the two files.
Any advice on how to assimilate the information in ppi-pm14400fxmt 
into my active configuration file?

I'm having another configuration problem.  My modem answers in data
(not fax mode).  Eventually as it goes through its auto-answer
sequence, it gets to the FAX mode, but often, the originating 
station times out before they have established a carrier.  I'm
using this modem for FAXing only, so I want it to answer in FAX
mode.  Again, I'm assuming this is a configuration file issue 
but I haven't been able to figure it out.

If anyone can give me some pointers, I'd sure appreciate it.

Thanks so much,
Jon

-------------------------------------------------------------------
Jon Wright          jwright@spudboy.com          voice 425-635-0338
                                                   fax 425-635-0339
I'm a potato and I'm so hip         http://www.spudboy.com/~jwright



Home
Report any problems to webmaster@hylafax.org

HylaFAX is a trademark of Silicon Graphics Corporation.
Internet connectivity for hylafax.org is provided by:
VirtuALL Private Host Services