Re: flexfax: Problems with haylafax and creatix modem

[Matthias.Apitz@SOFTCON.de]

Martin Klingler wrote:
    
    Hi to the mailing list,
    
    I am using Hylafax V4.Opl1 on the S.u.S.E. Distribution 5.0 with Creatix LC 144VF.
    
    I get the following error during sending and receiving of faxes. I have checked it with different remote partners, its always the same.
    
    Mar 04 21:39:01.18: [  331]: DIAL 04242232241
    Mar 04 21:39:01.19: [  331]: <-- [16:ATDT04242232241\r]
    Mar 04 21:39:18.98: [  331]: --> [5:+FCON]
    Mar 04 21:39:21.20: [  331]: --> [29:+FCSI: "         04242 23224"]
    Mar 04 21:39:21.20: [  331]: REMOTE CSI "04242 23224"
    Mar 04 21:39:21.46: [  331]: --> [22:+FDIS: 1,3,0,2,1,0,0,4]
    Mar 04 21:39:21.57: [  331]: --> [2:OK]
    Mar 04 21:39:21.57: [  331]: REMOTE best rate 9600 bit/s
    Mar 04 21:39:21.57: [  331]: REMOTE max page width 1728 pixels in 215 mm
    Mar 04 21:39:21.57: [  331]: REMOTE max unlimited page length 
    Mar 04 21:39:21.57: [  331]: REMOTE best vres 7.7 line/mm
    Mar 04 21:39:21.57: [  331]: REMOTE best format 2-D MR
    Mar 04 21:39:21.58: [  331]: REMOTE best 20 ms, 10 ms/scanline
    Mar 04 21:39:21.58: [  331]: USE 9600 bit/s
    Mar 04 21:39:21.58: [  331]: USE 20 ms, 10 ms/scanline
    Mar 04 21:39:21.58: [  331]: <-- [5:ATH0\r]
    Mar 04 21:39:21.83: [  331]: --> [9:+FHNG: 20]
    Mar 04 21:39:21.83: [  331]: REMOTE HANGUP: Unspecified Transmit Phase B error (code 20)
    Mar 04 21:39:22.82: [  331]: --> [2:OK]
    Mar 04 21:39:22.82: [  331]: SESSION END
    
    Has anybody an idea what the reason could be for this result.
    
    Thank You very much and best regards

Why is faxsend(1M) sending down the ATH0 to the modem?
Please check or show your modem config file.

	matthias