Re: flexfax: sendpage

[Matthias.Apitz@SOFTCON.de]

Tim Kutt wrote:
    
    Hello Everyone ! 
    
    I am having a few problems with sendpage, here is the session log, we are
    using Pagenet Canada. 
    
    Any Ideas ? 

The login prologue into Pagenet looks fine and the
syntax of the message too. Please check with Pagenet
why they're not accepting the message. There is a delay
of ~2 secs between pagesend(1M)'s message transmit and
the NAK response of Pagenet, looks like they are checking
something (e.g. to validate the correctness and completeness
of the pager number). But this is only a wild guess.
Ask Pagenet and show them the log.

	matthias

    
    --------------------------
    
    Your pager job to 9,2446161 failed because:
        Protocol failure: paging central responded to message block transmit
    with forced disconnect
    
        ---- Transcript of session follows ----
    
    Nov 21 18:03:21.96: [ 7338]: SESSION BEGIN 00001220 151992446161
    Nov 21 18:03:21.96: [ 7338]: SEND PAGE: JOB 668 DEST 9,2446161 COMMID 00001220
    Nov 21 18:03:21.96: [ 7338]: MODEM set DTR OFF
    Nov 21 18:03:21.96: [ 7338]: DELAY 2600 ms
    Nov 21 18:03:24.57: [ 7338]: MODEM set DTR ON
    Nov 21 18:03:24.57: [ 7338]: MODEM set baud rate: 2400 baud, input flow
    RTS/CTS, output flow RTS/CTS
    Nov 21 18:03:24.57: [ 7338]: MODEM flush i/o
    Nov 21 18:03:24.57: [ 7338]: <-- [15:ATE0V1Q0S0=0H0\r]
    Nov 21 18:03:24.69: [ 7338]: --> [2:OK]
    Nov 21 18:03:24.69: [ 7338]: <-- [21:ATS8=2S7=60&K3&D2&C1\r]
    Nov 21 18:03:24.83: [ 7338]: --> [2:OK]
    Nov 21 18:03:24.83: [ 7338]: <-- [5:ATM0\r]
    Nov 21 18:03:24.90: [ 7338]: --> [2:OK]
    Nov 21 18:03:24.90: [ 7338]: MODEM set parity: 7 bits, even parity
    Nov 21 18:03:24.90: [ 7338]: MODEM input buffering enabled
    Nov 21 18:03:24.90: [ 7338]: <-- [12:AT+FCLASS=0\r]
    Nov 21 18:03:25.10: [ 7338]: --> [2:OK]
    Nov 21 18:03:25.10: [ 7338]: DIAL 9,2446161
    Nov 21 18:03:25.10: [ 7338]: <-- [15:ATDT9,2446161@\r]
    Nov 21 18:03:42.72: [ 7338]: --> [12:CONNECT 2400]
    Nov 21 18:03:42.75: [ 7338]: EXPECT ID (paging central identification)
    Nov 21 18:03:42.75: [ 7338]: <-- <1:\015>
    Nov 21 18:03:44.74: [ 7338]: MODEM TIMEOUT: reading line from modem
    Nov 21 18:03:44.74: [ 7338]: <-- <1:\015>
    Nov 21 18:03:45.05: [ 7338]: --> <3:ID=>
    Nov 21 18:03:45.05: [ 7338]: RECV ID ("ID=")
    Nov 21 18:03:45.06: [ 7338]: SEND device identification/login request
    Nov 21 18:03:45.06: [ 7338]: <-- <5:\033PG1\015>
    Nov 21 18:03:46.64: [ 7338]: --> <1:\006>
    Nov 21 18:03:46.64: [ 7338]: RECV ACK (login successful)
    Nov 21 18:03:46.64: [ 7338]: --> <24:Processing - Please wait>
    Nov 21 18:03:46.65: [ 7338]: RECV: Processing - Please wait
    Nov 21 18:03:46.83: [ 7338]: --> <3:\033[p>
    Nov 21 18:03:46.83: [ 7338]: RECV go-ahead (prologue done)
    Nov 21 18:03:46.84: [ 7338]: SEND message block
    Nov 21 18:03:46.84: [ 7338]: <-- <29:\0025190400920\015test to
    tee\015\00363>\015>
    Nov 21 18:03:48.31: [ 7338]: --> <1:\025>
    Nov 21 18:03:48.31: [ 7338]: RECV NAK (message block rejected)
    Nov 21 18:03:48.31: [ 7338]: SEND message block (retransmit)

	<... log truncated ...>