Re: flexfax: Routing of incoming fax

[David Woolley <david@djwhome.demon.co.uk>]

> The idea is to route trough e-mail a incoming fax to the destination,
> but I don't have any up-to date information about the capabilities of
> fax protocols in general and Hylafax to manage routing information.

Hylafax can route on the sender's id.

> There are any experience and/or patch to Hylafax to use some of method
> for it like DID or T.30 subaddressing or other?
> There any modem able to support this kind of protocol?

DID would require special capabilities in the PABX.  However, any Class
1 modem would be tranparent to T.30 protocol.  I'd have to check whether
the information is forwarded by Class 2.

FAXRCVD(1M)                                           FAXRCVD(1M)

NAME
       faxrcvd - HylaFAX notification script for received facsim-
       ile

.....
       This  script  can route facsimile directly to the intended
       receipient if the sender's identity is well-known.  To  do
       this create a shell script etc/FaxDispatch in the spooling
       area that sets  the  receiver's  electronic  mail  address
       according to the sender's TSI.  For example,

       case "$SENDER" in
       *1*510*526*1212*) SENDTO=sam;;          # Sam's test rig in Berkeley
.....